Using and testing with our Chassis Dyno is a high energy event which may damage your car's components during testing. We have run many cars with great results and run them safely. IF ANYTHING is loose in the rotating mass, it may damage the car or hit you.
With all that in mind, under these conditions we will test your car. You MUST agree to them prior to adding this service to cart, checking out or car test:
- Prior to presenting car for the test, you will confirm you have examined all drive parts and checked all fasteners for tightness. ESPECIALLY check that the rear wheels are tight!
- The car will be complete (except body) including wheels/tires, suspension, ESC, motor, LiPo pack. We will not need receiver (it can be left in car) or radio.
-
We will not be responsible if any part of your car suffers damage while being tested, including labor or parts, for any reason. We will not be responsible for any burn, cut, puncture etc. to your person. This includes but is not limited to:
- LiPo Pack
- ESC
- Wiring
- Motor
- Transmission, gears, slipper or Diff
- Bearings
- Dogbones, CVD, axles
- Tires may come off wheels (make sure you have very good glue application).
- You will stand clear of the rear of the car when testing begins. The rear wheels, and the transmission drive system turns with power and high speed which will accelerate loose parts at speed at you:
- Do not reach or touch any part of car while it is testing.
- Stand to the left or right of the car (not behind it).
- Do not wear or use clothes, etc. which is long enough to reach the car during testing. A hair pull can be painful if wrapped around fast accelerating rotating parts!
- Safety glasses are suggested (you supply your own).